Paul shows that with a little practice superbly frothed milk is not too hard to achieve and once mastered allows you to make superb cappuccinos, lattes, macchiatos and all the other milk based coffee drinks.



How to froth milk (Video) – Barista Tips is a post from: Caffe Society Blog This feed and all content © 2010 Caffe Society Ltd

Foaming milk

1 – Put FRESH COLD milk in a straight sided or belly jug. Use a minimum of a third and a maximum of half a jug of milk.

2 – Purge the steam wand by turning it on for 5 seconds, this also helps build pressure in the wand.

3 -Position the tip of the steam wand just under the surface of the milk and turn the steam wand on to full power.
Listen for a high pitched chirping sound. If the wand is too high you will hear a splattering sound and if the wand is too low the sound will go silent.

4 – As the milk froths lower the jug to keep the tip of the wand just under the surface and maintain the chirping sound.

5 – When the temperature reaches 40-45°c switch to texturing the milk. When you first start learning to froth milk you should use a milk thermometer to measure the temperature. With practice you should be able to judge the temperature by touch alone.



Texturing milk

6 – Lower the steam wand a couple of centimeters under the surface of the milk, position it onto the side of the jug and angle the jug slightly. This will cause a whirlpool effect in the jug, which will break down and bubbles and create a dense smooth foam.

7 – When the temperature reaches 60°c fully turn the steam wand off. The thermometer will have a slight delay in registering the heat so the final temperature will be around 65-70°c.

8 – Give the base of the jug a firm tap on your counter top to break any surface bubbles. At this point make sure you clean the steam wand with a damp cloth to stop the milk drying on the wand. Don’t touch the wand with your hand as it will be very hot!

9 – Now go and make your espresso, the base of all Italian specialty coffee drinks, which will give your milk a minute to settle.

10 – Once your ready to add the milk to the espresso, start by swirling the milk in the jug. The foamed milk should have formed a ‘dry’ lump in the middle of the jug, keep swirling until this is all mixed back in and the milk flows like thick shiny cream.

11 – Before pouring, give the milk a final swirl to stop any foam from sticking to the jug.

12 – Get the jug close to the cup with your espresso in, pour with a slight wiggle side to side to help the foam pour from the jug. Pour off centre to retain a clean white foam centre with a halo of crema. When the cup is a third full of foam, stop the wiggle, lift the jug slightly higher and pour through the liquid milk.


Still need a little more help or would just like to see milk frothing in action? Check out our how to froth milk video with Head Judge for the World Latte Art Championship, Paul Meikle-Janney.


We can supply all the barista tools needed to froth milk, or if you would like expert help we can provide barista training.

How to froth milk – Barista Tips is a post from: Caffe Society Blog This feed and all content © 2010 Caffe Society Ltd